Home > 学习 | 工作 > CentOS5.5启动x桌面报错解决方案

CentOS5.5启动x桌面报错解决方案

上篇里提到CENTOS5.5安装GNOME桌面,安装后,更新完软件包,重启,运行startx命令报错了:

X Window System Version 7.1.1
Release Date: 12 May 2006
X Protocol Version 11, Revision 0, Release 7.1.1
Build Operating System: Linux 2.6.18-53.el5 i686 Red Hat, Inc.
Current Operating System: Linux test.kinsun 2.6.18-274.18.1.el5PAE #1 SMP Thu Fe                                                                                        b 9 13:25:50 EST 2012 i686
Build Date: 06 October 2011
Build ID: xorg-x11-server 1.1.1-48.76.el5_7.5
        Before reporting problems, check http://wiki.x.org
        to make sure that you have the latest version.
Module Loader present
Markers: (–) probed, (**) from config file, (==) default setting,
        (++) from command line, (!!) notice, (II) informational,
        (WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/var/log/Xorg.0.log", Time: Mon Feb 20 13:21:20 2012
(==) Using config file: "/etc/X11/xorg.conf"
Parse error on line 29 of section Screen in file /etc/X11/xorg.conf

(EE) No devices detected.

Fatal server error:
no screens found
XIO:  fatal IO error 104 (Connection reset by peer) on X server ":0.0"
      after 0 requests (0 known processed) with 0 events remaining.

进入/etc/X11/xorg.conf看了配置文件,应该是VGA驱动问题,之后尝试运行setup和system-config-display来调整都失败了:

[root@test ~]# setup
Couldn’t start X server on card 0
无法使用旧的配置启动 X 服务器,请试用一个新配置
Couldn’t start X server on card 0
错误,启动 X 服务器失败。
Couldn’t start X server on card 0
无法使用旧的配置启动 X 服务器,请试用一个新配置
Couldn’t start X server on card 0
错误,启动 X 服务器失败。

还好在chinaunix上看到一个帖子,重新生产一个新的xorg.conf配置文件,替换掉就可以了:

yum install xorg-x11-server-Xorg

Xorg -configure :0

cp /root/xorg.conf.new /etc/X11/xorg.conf

startx

之前我也曾运行过xorg -configure这个命令,X没有大写,所以提示“没有这个命令”,以为是包没有安装,输入yum install xorg-x11-server-Xorg,提示已经安装了,然后我以为连xorg的命令都失效了呢…

原创文章,转载请注明: 转载自三叶草

本文链接地址:http://www.anjing.me/1361.html

特别声明:商业网站转载需经作者同意,否则视为侵权!

相关日志

POSTED ON 2012/02/20, , , ,

Leave a Reply

TOP